TRENDnet User's Guide
Configure the SNMP Trap Management
System > SNMP > Host Settings
A Host IP address is used to specify a management device that needs to receive SNMP
traps sent by the switch. This IP address is associated with the SNMP Version and a valid
Community Name in the Host table of the switch.
1. Log into your switch management page (see "Access your switch management page"
on page 6).
2. Click on System, click on SNMP, and click on Host Settings.
3. Review the settings.
Create Trap Host Table Entry
Use the following procedure to create a trap Host table entry:
Enter the Host IP Address for the management device that is to receive the
SNMP traps.
Select the SNMP Version, either v1 or v2c, that is configured for the host
management device.
Enter a Community Name that you have defined previously in the SNMP
Community table. The Community Name must correlate with one of the
communities displayed on the SNMP Community Table page. If you enter a
Community Name that has not been pre‐defined, the Trap Host entry is
displayed, but agent/manager communication fails.
4. Click Apply. The new host is added to the table.
© Copyright 2018 TRENDnet. All Rights Reserved.
5. In the left hand panel, click on Save
6. Click Save Settings to Flash, then click OK.
Note: This step saves all configuration changes to the NV‐RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE‐TG82ES
13