Configure Vlan Port Settings - TRENDnet TPE-224WS User Manual

TRENDnet User's Guide
Click Apply to save the new VLAN to the table.
In the list, you can click Modify to modify an entry or click Delete or delete the entry. If
the entries span multiple pages, you can navigate page number in the Page field and
click Go or you can click First, Previous, Next, and Last Page to navigate the pages.
Note: The default VLAN VID1 cannot be removed.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2014 TRENDnet. All Rights Reserved.

Configure VLAN Port Settings

Bridge > VLAN > Port Settings
In this section, you can modify the port VID settings, acceptable frame types, and
ingress filtering.
1. Log into your switch management page (see
on page 7).
2. Click on Bridge, click on VLAN, and click on Port Settings.
3. Review the settings for each port. Click Apply to save settings.
• PVID – Enter the port VLAN ID. Note: Required for untagged VLAN ports.
• Acceptable Frame Type – Click the drop-down list and select which type of
frames can be accepted.
All – The port can accept all frame types.
o
Tagged – The port can accept tagged frames only. Untagged frames
o
are discarded.
Untagged & Priority Tagged – The port can accept untagged frames
o
and frames with tagged priority information only such as 802.1p.
• Ingress Filtering –Click the drop-down list and select Enabled to enable ingress
filtering or Disabled to disable ingress filtering.
Note: Modifying settings in the row marked All, will apply the settings to all
ports.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
TPE-224WS
"Access your switch management page"
36