Mirroring; Configure Port Mirror Settings - TRENDnet TPE-224WS User Manual

TRENDnet User's Guide

Mirroring

Configure port mirror settings

Bridge > Mirroring
Port mirroring allows you to monitor the ingress and egress traffic on a port by having
the traffic copied to another port where a computer or device can be set up to capture
the data for monitoring and troubleshooting purposes.
1. Log into your switch management page (see
on page 7).
2. Click on Bridge, click on Trunk Config, and click on Port Priority.
3. Review the settings. Click Apply to save changes.
• Status – Click the drop-down and list and select one of the following options:
Enable - This parameter activates the Port Mirroring feature and the
o
rest of the configuration parameters become active on the page.
Disable - This parameter de-activates the Port Mirroring feature and
o
the rest of the configuration parameters become inactive on the page.
•
Mirror Target Port – Click the drop-down and list and select the port to send
the copied ingress/egress packets/data. (e.g. Computer or device with packet
capture or data analysis program.)
Check the port to monitor or copy inormation from. (Source)
To copy data received on a specific port, check the port number(s) under the Ingress
Port section or you could click All to copy data received on all ports.
© Copyright 2014 TRENDnet. All Rights Reserved.
"Access your switch management page"
To copy data transmitted on specific port, check the port number under the Egress Port
section or you could click All to copy data transmitted on all ports.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE-224WS
28