Bandwidth Control; Configure Storm Control - TRENDnet TPE-224WS User Manual

TRENDnet User's Guide
To modify an entry, click Modify to add statically add router ports.
Check the static router ports to add and click Apply to save the settings.
Note: You can click on All to add all ports. Clicking Restore will restore the static router
port settings to default.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
© Copyright 2014 TRENDnet. All Rights Reserved.

Bandwidth Control

Configure Storm Control

Bridge > Bandwidth Control > Storm Control
This section allows you to configure the DLF (Destination Lookup Failure), broadcast,
and multicast storm settings for each switch port.
1. Log into your switch management page (see
on page 7).
2. Click on Bridge, click on Bandwidth Control, and click on Storm Control.
3. Review the settings for each port. Click Apply to save the settings.
•
DLF (Destination Lookup Failure) – Click the drop-down list and select Enabled
to enable DLF storm control.
•
Broadcast – Click the drop-down list and select Enabled to enable broadcast
storm control.
• Multicast – Click the drop-down list and select Enabled to enable multicast
storm control.
• Threshold – Enter the pps (packets per second) threshold.
Note: Modifying settings in the row marked All, will apply the settings to all
ports.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TPE-224WS
"Access your switch management page"
33