Physical Specifications - Cisco uBR-3x10 Hardware Installation And Cabling Manual

Specifications and Component Part Numbers
This appendix provides information on physical and RF specifications for the
Cisco uBR 3x10 RF Switch.

Physical Specifications

The following table lists the physical specifications and power requirements for the
Cisco uBR 3x10 RF Switch.
Table A-1 Physical Specifications
Description
Dimensions (H x W x D)
Weight
AC-input voltage rating
AC-input current rating
AC-input cable
AC frequency
DC-input voltage rating
DC-input current rating
DC-input cable
DC voltage supplied
Temperature
Software requirement
Regulatory compliance
OL-1984-06
Specification
19 x 15.5 x 5.25 in. (842 x 384 x 132 mm)
36 lb (16.6 kg)
100 to 240 VAC (Operating Range: 90 to 254 VAC)
0.5 A
18 AWG three-wire cable, with a three-lead IEC-320 receptacle on the power supply end
and a country-dependent plug on the power source end
50-60 Hz
-48 to -60 VDC (Operating Range: -40.5 to -72 VDC)
0.7A
2
14 AWG (2.5 mm ) minimum recommended
+12V
Operational temperature range:32 to 104°F (0 to +40°C)
Operating temperature range:23 to 151°F (-5 to +55°C)
Cisco IOS Release 12.2(8)BC2 or later version of Cisco IOS Release 12.2BC
Safety: CSA950/UL1950, EN60950, IEC 60950, ACAN TS001, AS/NZS3260
EMC Emissions: CFR 47 part 15:2000 Class B; EN55022:1998 Class B; EN300386:2000;
AS/NZS 3548:1995 Class B; CISPR22:1997 Class B; VCCI-3/2000.04; ICES-003:1994;
CNS13438:1997 Class B
EMC Immunity: EN61000-3-2:1995; EN61000-3-3:1995; EN55024:1998;
EN50082-1:1992; EN50082-1:1997
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
A P P E N D I X
A
A-1