Cisco uBR-3x10 Hardware Installation And Cabling Manual page 99

Chapter 5 Cabling the RF Switch With the Cisco uBR7246VXR CMTS
Figure 5-9
16
Table 5-9 DS Cables from VXRs to Upconverter Ports (by Router)
Color VXR1/VXR2
Red LC1–DS
White LC2–DS
Blue LC3–DS
Green LC4–DS
Yellow LC1–DS
Purple LC2–DS
Orange LC3–DS
Black LC4–DS
Cabling the Output Ports (Upconverter to RF Switch)
This section describes cabling from the output ports on the upconverter to the RF switch.
Equipment
•
To cable the output ports on the upconverter, complete the following steps. Refer to
Figure
Connect the cable to the output connector (1–lower) on the upconverter.
Step 1
Run the cable under the RF switch to the rear of the chassis.
Step 2
Connect the cable to the 1F port on RFS-2.
Step 3
Repeat
Step 4
OL-1984-06
Cabling the Upconverter (MC16x to UPx1)
15 14 13 12 11 10 9
UPx1 Input VXR3/VXR4
1 LC1–DS
2 LC2–DS
3 LC3–DS
4 LC4–DS
5 LC1–DS
6 LC2–DS
7 LC3–DS
8 LC4–DS
20 cables (F-connector to MCX connector—gray and brown)
5-10.
Step 1 through Step 3 for the remaining cables.
Connecting the Cables (Cisco uBR-MC16x Card)
8 7 6 5 4 3 2 1
UPx 2
UPx 1 UPx 1
UPx1 Input
9
10
11
12
13
14
15
16
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
To UPx1
VXR1
VXR5 UPx2 Input
LC1–DS 1
LC2–DS 2
LC3–DS 3
LC4–DS 4
— —
— —
— —
— —
Table 5-10 and
5-13