Tools for Installation
Cable management bracket (optional)
•
Figure 2-4
Tape measure (optional)
•
Level (optional)
•
14 American Wire Gauge (2.5 mm
•
140°F (60°C) (for DC-input power supply installations only)
Standard wire stripper (for grounding wire and DC-input power supply installations)
•
Tape (for securing the handle of a DC circuit breaker in the OFF position when a DC-input power
•
supply is powered down)
The rack-mount kit includes the following parts:
Two rack-mount brackets for mounting the chassis in the rack
•
Four M5 x 8-mm Phillips countersunk screws to secure the rack-mount brackets to the chassis
•
To verify your plant's RF setup, you need the following:
Cisco uBR 3x10 RF Switch cabling bundles supplied by Cisco Systems, Inc. or WhiteSands
•
Engineering, complete with header blocks and MCX connectors. For more detailed information,
refer to the
Numbers" section on page
Vecima HD4040 series IF-to-RF upconverter (when needed)
•
RF spectrum analyzer
•
For coaxial cabling:
•
–
–
–
–
For fiber networks, fiber-optic laser receivers for each upstream channel
•
Assorted RF attenuators (with at least two 20-dB attenuators)
•
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
2-10
Optional Cable Management Bracket for the Cisco uBR10012 Chassis
"RF Cable Assemblies" section on page 4-4
A-1.
Diplex filters and splitters
Coaxial cable crimping tool
New coaxial cable
Coaxial jumpers that are at least two to three feet long (maximum of five feet)
2
) cable with a minimum of three conductors rated for at least
and
"Specifications and Component Part
Chapter 2
Preparing for Installation
OL-1984-06