Cisco uBR-3x10 Hardware Installation And Cabling Manual page 72

Connecting the RF Cables (MC16x, MC28C Line Cards)
Figure 4-12
16 15
Table 4-4 Cisco uBR10-LCP2-MC28C Cabling (DS Ports to the Upconverter)
Color Line Card Slot
Brown 8/0—working
Gray 8/0—working
Brown 8/1—working
Gray 8/1—working
Brown 7/0—working
Gray 7/0—working
Brown 7/1—working
Gray 7/1—working
Cabling the Output Ports from the Upconverter to the RF Switch
This section describes cabling from the output ports on the upconverter to the RF switch.
Equipment
•
•
To cable the output ports on the upconverter to the RF switch, complete the following steps.
Connect the cable to the output connector (1–lower) on the upconverter.
Step 1
Connect the cable to the appropriate MCX connection on the CABLE PLANT header block.
Step 2
•
•
Repeat
Step 3
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
4-18
Chapter 4
Cabling the Input Ports on the Upconverter (MC28C)
14 13 12 11 10 9
DS Port UPx Conn
DS1 16
DS0 15
DS1 14
DS0 13
DS1 12
DS0 11
DS1 10
DS0 9
8 cables for Cisco uBR10-LCP2-MC16x cards (F-connector to MCX connector–gray)
16 cables for Cisco uBR10-LCP2-MC28C cards (F-connector to MCX connector–gray, brown)
For Cisco uBR10-LCP2-MC16x cards, see
For Cisco uBR10-LCP2-MC28C cards, see
Step 1 through Step 2 for the remaining cables
Cabling the RF Switch With the Cisco uBR10012 CMTS Cable Interface Line Cards
8 7 6 5 4 3 2 1
Color Line Card Slot
Brown 6/0—working
Gray 6/0—working
Brown 6/1—working
Gray 6/1—working
Brown 5/0—working
Gray 5/0—working
Brown 5/1—protect
Gray 5/1—protect
Table 4-5 on page
Table 4-6 on page
Input
DS Port UPx Conn
DS1 8
DS0 7
DS1 6
DS0 5
DS1 4
DS0 3
DS1 2
DS0 1
4-19.
4-19.
OL-1984-06