Cisco uBR-3x10 Hardware Installation And Cabling Manual page 64

Mapping the RF Cables from the Working and Protect Line Cards (MC16x, MC28C) to the Cisco uBR 3x10 RF Switch
Mapping the RF Cables from the Working and Protect Line Cards
(MC16x, MC28C) to the Cisco uBR 3x10 RF Switch
This section provides guidelines for mapping the RF cables and contains the following subsections:
•
•
This sample mapping (or any other valid mapping method) is applicable to both working and protect
Note
cable interface line cards when employing N+1 redundancy.
Figure 4-7
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
4-10
Chapter 4
Mapping the Cisco uBR10-LCP2-MC28C Cable Interface Line Cards to the RF Switch, page 4-13
Mapping the Cisco uBR10-LCP2-MC16x (C,E,S) Cable Interface Line Cards to the RF Switch,
page 4-11
Cable Interface Line Card Slot Numbers (Cisco uBR10-LCP2-MC28C Line Card Shown)
CIS CO
100 00 CIS CO
CIS CO
100 00
100 00
Cable interface slot 5/1
Cable interface slot 5/0
Cable interface slot 6/1
Cable interface slot 6/0
Cable interface slot 7/1
Cable interface slot 7/0
Cable interface slot 8/1
Cable interface slot 8/0
Cabling the RF Switch With the Cisco uBR10012 CMTS Cable Interface Line Cards
TCC+ card slot 1/1
TCC+ card slot 2/1
CIS C
100
Uplink line card slot 4/0
Uplink line card slot 3/0
Uplink line card slot 2/0
Uplink line card slot 1/0
OL-1984-06