Table of Contents
Advertisement
Chapter 5
Cabling the RF Switch With the Cisco uBR7246VXR CMTS
Cabling the Output Ports (Upconverter to RF Switch)
The following section describes cabling from the output ports on the upconverter to the RF switch.
Equipment
•
To cable the upconverter to the RF switch, complete the following steps. Refer to
Connect the cable to the output connector (1–lower) on the upconverter.
Step 1
Step 2
Run the cable under the RF switch to the rear of the chassis.
Step 3
Connect the cable to the F1 port on the header block.
a.
b.
c.
Repeat
Step 4
header blocks.
Use different colored cables for each connection. The example shows alternating gray and brown.
Tip
Figure 5-16
OL-1984-06
40 cables (F-connector to MCX connector—gray and brown)
See
Table 5-18 on page 5-24
See
Table 5-19 on page 5-24
See
Table 5-20 on page 5-24
Step 1
through
Step 3
for the remaining cables, alternating between the F and M ports on the
Output Cables (Gray and Brown)
16
15
14
13
12
11
10
9
Connecting the Cables (Cisco uBR-MC28x Line Card)
for UPx1.
for UPx2.
for UPx3.
8
7
6
5
4
3
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
Figure
2
1
UPx 3
UPx 2
UPx 1
5-15.
5-23
Advertisement
Chapters
Table of Contents
