Cisco uBR-3x10 Hardware Installation And Cabling Manual page 119

Chapter 6 Troubleshooting
Cisco uBR 3x10 RF Switch Slot Information
Table 6-6
Tip The modules are listed as seen from the front of the RF switch.
8
Table 6-6 Switching Matrix for the Cisco uBR 3x10 RF Switch (Upstream and Downstream Modules)
RFS
Module Working Ports
2 1H—8H
4 1I—8I
6 1J—8J
8 1K—8K
10 1L—8L
12 1M—8M
14 not used
1. P2 is used only when the switch is in 4 + 1 mode.
Figure 6-3
OL-1984-06
lists the RF modules and the ports assigned to each module.
PROTECT Ports Type
1
P1H, P2H upstream
P1I, P2I upstream
P1J, P2J upstream
P1K, P2K upstream
P1L, P2L upstream
P1M, P2M downstream
— —
RF Switch from Front
Captive screw
RFS
Module Working Ports
1 1A—8A
3 1B—8B
5 1C—8C
7 1D—8D
9 1E—8E
11 1F—8F
13 1G—8G
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
Troubleshooting the Installation and Setup
PROTECT Ports Type
P1A, P2A upstream
P1B, P2B upstream
P1C, P2C upstream
P1D, P2D upstream
P1E, P2E upstream
P1F, P2F downstream
P1G, P2G downstream
Captive screw
6-7