Cloning Using Tftp - Xerox Phaser 4622 System Administrator Manual

6. In the Install Clone File area, click on the Browse button.
If prompted, enter the Administrator's User ID admin and Password 1111 and click on Login.
7. Click on the .dlm cloning file located on the laptop or PC.
8. Click on Open.
9. Click on Install to submit the file to the machine.
The machine will not be available over the network for several minutes.

Cloning Using TFTP

This feature provides a mechanism for delivering a created configuration file from a network server to
the printer via TFTP. On power up a device with TFTP enabled shall attempt to run a configuration file
(clone file) from a TFTP server.
To use this feature a TFTP server must be installed and running on your network with a clone file saved
to the TFTP root directory.
To configure TFTP settings:
1. At your Workstation, open the web browser, enter the TCP/IP Address of the machine in the
Address bar.
2. Press Enter.
3. Click on the Properties tab.
4. Click on the Connectivity link.
5. Click on the Protocols link.
6. Click on the TFTP link.
7. Click the checkbox to enable TFTP.
8. The TFTP Server Name and Boot File Name can be entered directly into the fields or they can be
acquired using DHCP options 66 and 67. This will overwrite the values saved from the CWIS TFTP
settings page.
9. To setup options 66 and 67 go to your DHCP server and open your Server Manager. Go to DHCP >
your server name > Scope Options.
10. Under 066 Boot Server Host Name enter the host name of the machine running the TFTP server.
Under 067 Bootfile Name enter the name of the clone file saved in your TFTP root directory.
Network Installation
Phaser 4622
System Administrator Guide
37