Access Cwis; Network Factory Default Button - Xerox Phaser 4622 System Administrator Manual

Access CWIS

Use these instructions to access CWIS, the embedded web pages resident in the machine.
1. Open the web browser from your Workstation.
2. In the URL field, enter http:// followed by the IP Address of the machine. For example: If the IP
Address is 192.168.100.100, enter the following into the URL field: 192.168.100.100.
3. Press Enter to view the Home page.
4. Click a tab to access the desired page, or click on the Index icon at the top of the machine web
page to access the index and contents list.

Network Factory Default button

This button can be found on the Status tab and is used to reset Network parameters to factory default
values from the Internet. It causes the machine to set all Network values back to factory default. This
will cause an immediate image overwrite of any incomplete print jobs being processed when the
Network Controller is rebooted.
Once the button is selected, the following will occur:
1. If the System Administrator is already authenticated as an administrator the machine will reboot.
The web-browser will not be able to connect to the machine via the Web UI until the network
controller has reset.
2. If the System Administrator is not already authenticated, the Administration Authentication
screen will appear so authentication can be performed. Once this has successfully occurred, the
Administration Authentication screen will close and the machine will reboot. The web browser
will not be able to connect to the machine via the CWIS until the Network Controller has been
reset.
CentreWare Internet Services
Phaser 4622
System Administrator Guide
111