Forward-Facing Latch Installation - Diono RadianRXT Instruction Manual

Forward-Facing LATCH Installation

for children 20 lbs – 80 lbs
WARNING:
• Remove detachable base when
restraint is forward-facing.
• Do NOT place infant in forward-facing restraint until
1 year and 20 lbs.
• ALWAYS use SafeStop with LATCH installation for
forward-facing child below 40 lbs. (See page 28 and 30).
• This restraint features the SuperLATCH® installation
system. Vehicle's lower anchor points or top tether can be
used to install this restraint for a child weighing up to 80
lbs in vehicles made after September 2005. For vehicles
made before September 2005, consult vehicle manual for
lower anchor and tether limits.
• See page 42 for LATCH
connector instructions.
Fig. 1 shows a typical forward-
facing installation with LATCH.
If forward-facing recline is
desired, adjust it prior to
installation (see page 29 ).
1. Confirm vehicle seating
location has its own LATCH anchors. If it does not, you
must use vehicle seat belt installation (see pages 22 and
24).
2. Locate LATCH belting secured in storage compartment
on restraint back. Press red release button to remove
each LATCH connector and webbing. Slide the narrow
LATCH tethering strap out of plastic strap guides on
side of the seat.
3. Place restraint in forward-
facing position.
Stability of installation can be
improved by using top tether
shown in blue, Fig. 1 (see page
28 for top tether instructions).
4. Route LATCH belt through
forward-facing belt path
and behind restraint cover.
(Fig. 2)
1
2
2
20
Meijer.com