Table of Contents
Advertisement
Switch the power ON. When the printer
is ready, set the LASER POWER CHECK
switch of the driver tester to "ON".
<*y.
,
1
Set the meter range to 20 VDC. Contact the
test leads against the following
connector pins on the DC controller PCS:
r
DC controller
f%??
V-D
J206-6 (APCOUT)
COM
J206-7 (GND)
<Tp
CHECK switch of the driver tester
1
Switch the power OFF, and
laser/scanner unit.
End
:
YES
YES
Switch the power OFF, and replace the DC
Set the meter range to 20 VDC. Contact the
test leads against the following
connector pins on the DC controller PCB:
_M%
V-D
COM
Does the meter indicate 0.95 to
CHECK switch of the driver tester
The laser/scanner unit is working normally.
+
Figure 6 - 8
CHAPTER 6
t
DC controller
J206-5 (APCIN)
5206.7 (GND)
6 - 1 3
Advertisement
Table of Contents
