Table of Contents
Advertisement
b. Regist Paper Sensor and Cassette
Paper Sensor
I) Kemove the cassette pick-up roller.
2) Disconnect the connector.
Figure 3-21
3-8
3) Remove the pin in the projection on the
left end of the regist sensor holder and
push the projection.
Then, take off two claws on the right
side, and slide off the regisl sensor
holder unit lo the left.
Slide the left end of the regist sensor
holder toward the cassette feed roller
shaft (front in the figure) so that it does
not touch lhe oblique roller.
0 Projection
0 Claws
(3 Regist sensor holder unit
Figure 3-22
4) Remove the sensors from regist sensor
holder unit.
@ Regist paper sensor
0 Cassette paper sensor
F-&we 3-23
Advertisement
Table of Contents
