CHAPTER 3
A. Fixing Unit
1. Configuration
fixing unit fries the toner image onto
The
the paper. I1 is configured as shown below,
9) Separation guide
:3 Thermistor
(5) Thermoswitch
6 Fixing unit entrance guide
( 7 % Lower fixing roller
Figure 3-34
3 - 1 4
@ Upper fixing roller
w Fixing roller heater
2.
Removing the fixing roller
Open the delivery cover.
1)
Remove the two screws, lift the fixing
2)
unit slightly. and pull it forward and
out.
C2 Fixing unit
3 Screws
Figure 3-35
When you replaced the fixing unit,
Note:
push the metal levers on both
sides of the new king unit down.