CHAPTER 3
1. Removing the drive
1) Release the two claws, and remove the
0 Claws
Figure 3-74
2) Remove the screw, release the two claws,
and open the PCB cover.
0 Screw
0 PCB cover
Figure 3-76
3) Disconnect the two connectors and
remove the cable tie.
3 - 28
unit
G) Front rover
0 Claws
4) Remove the two screws and then remove
drive unit.
ZZ Connectors
@ Screws
Figure 3-76
0 Cable tie
@ Drive unit