Table of Contents
Advertisement
CILWTER 4
)ImuamKdh
If the boxed prinler is brought into the warm from a cold storeroom or delivery truck, condense-
lion will form on the printer surfaces. This will cause various problems, such as print defects. To
stop this happening, make sure you leave the printer in its box to gradually warm up to room
temperature before unpacking it. This will take al least an hour.
1. Unpacking
r
ACliOIl
teP
/
1
Open the box.
2 [ Take all the ancillary parts and
the documentation out.
Lift off the Styrofoam pads (right
!
and left), then lift the
i out.
4
Take the printer out of its plastic
bag. Peel off the tape holding the
vartous components.
5 Take the cassette out and remove
) tie
lifting plate retainer from the
cassette.
6 Open the printer and remove
the tape and the spacer
inside the printer.
7
Remove the packing material
holding the transfer charging
roller.
8
Open the multi-purpose tray
and remove the protective
sheet.
'
9
Open the delivery cover and
remove the sheet and the spacer.
Push the metal levers on both
sides of the Axing unit down.
4-2
:
'D
BIPk3u3~%~Yt
A
A
I
Check you have the following:
Power cord
l
Manual
l
Cartridge
l
printer
Figure 4-2
01
Check
i See Figure 4-2.
Remarks
Transfer charging roller
Advertisement
Table of Contents
