Setting Up Dvr Passwords; Figure 3-58 Callback Center (Modem) Setup Screen - Honeywell HRSD4 User Manual

Configuration
1.
2.
3.
4.

Setting Up DVR Passwords

An Administrator password is required for the following actions:
•
•
•
•
•
•
94
Figure 3-58
Highlight the field beside Pager Number and enter the telephone number of the
pager. Enter the number as it must be dialed from your telephone system. For
example, if you must dial 9 for an outside line, enter 9 before the pager number.
Highlight the field beside Mailbox and use the virtual keyboard to enter the voice
mailbox number if your pager uses a voice mailbox.
Highlight the field beside Site ID and use the virtual keyboard to enter a three-digit
site ID number.
Note The DVR waits for at least four minutes between pages. If
another event occurs less than four minutes after the DVR has
notified a pager, it does not dial the pager again. The DVR is
programmed this way so that the telephone line does not get
tied up.
Save your changes by highlighting OK and pressing
the screen without saving the changes.
to turn off the system
to enter the setup screen
to load default setups
to clear all data
to change system date and time
to change the Administrator password
Callback Center (Modem) Setup Screen
. Select Cancel to exit