Typical Dvr Installation; Setting The Dvr For Ntsc Or Pal - Honeywell HRDE4X4 User Manual

Typical DVR Installation

LAN for Remote
Access Software
Connection

Setting the DVR for NTSC or PAL

Before turning on your DVR, set the switch (see
equipment. If your DVR is already powered, unplug the power cord from the wall outlet.
Wait a few seconds, set the switch (see
Note You cannot mix NTSC and PAL equipment. For example, do not connect
NTSC cameras when your DVR is set to PAL. Similarly, do not connect a
PAL camera and an NTSC monitor.
Rev 3.01
Four Video Inputs for Cameras
Four Audio
Inputs
1 Internal Sensor
Output Relay
Four Sensor
Inputs
Figure
Audio Line
Output
CCTV Monitor
Figure 2-1) to NTSC or PAL to match your
2-1), and then re-apply power.
6
RS-232 for
Engineering Use
To 12 VDC
Adapter
VGA Monitor
Document 900.0399
08/08