The Jupiter-50'S System Settings; Making System Settings; Saving The System Settings; System Parameters - Roland Jupiter-50 Owner's Manual

The JUPITER-50's System Settings

Making System Settings

These settings apply to the entire JUPITER-50; for example, here you
can set the tuning and specify how MIDI messages will be received.
1.
In the Menu screen (p . 35), choose "System" and press the
[ENTER] button .
The SYSTEM MENU screen will appear.
2.
Select the item that contains the settings you want to
change, and press the [ENTER] button .
Item Explanation

Setup

Overall settings
Sound settings for the Part sound
Live/Tone Buttons
buttons
View the software version and
Information the USB flash drive's available free
space
3.
Choose the parameter that you want to set, and change
its value .

Saving the System Settings

System settings will return to their original values when you turn off
the power. If you want the settings you've made to be remembered
after the power is turned off, you must save the system settings.
1.
In either the SYSTEM SETUP screen, the SYSTEM LIVE SET/
TONE BUTTONS screen, or the SYSTEM INFORMATION
screen, press the [WRITE] button .
The screen will ask "Are you sure?"
2.
Press the [F5] (OK) button .
A message will indicate "Completed!" and the settings will be saved.
NOTE
Never turn off the power while settings are being saved.

System Parameters

This section explains what each system parameter does, and how
the parameters are organized.
SETUP
These settings apply to the JUPITER-50 as a whole.
SOUND ([F1] button)
Parameter
Sound
Page
Local Switch
p. 75
p. 78
Master Tune
p. 78
Master Key Shift
Master Level
Output Gain
Song Level
Tone Remain
Output Assign
Here you can specify which sounds will be sent from each output jack. Select the
desired check boxes for each output jack (MAIN OUT, SUB OUT).
Upper
Solo
Perc/Lower
Reverb
USB Song/Audio IN
USB Audio
Metronome
Value Explanation
Specifies whether the controller section
(keyboard, pitch bend/modulation lever,
[S1] [S2] buttons, D-BEAM controller, pedals,
etc.) will be connected to the internal sound
OFF, ON
generator. Normally, this should be left at
"ON. " Turn it "OFF" if you want to use the
JUPITER-50's controllers only to control an
external sound generator.
415.3–466.2 Sets the JUPITER-50's overall tuning (the
[Hz] frequency of the A4 key)
Shifts the JUPITER-50's overall pitch range in
-24–+24
semitone steps.
Sets the JUPITER-50's overall volume (except
0–127
for the signal from the USB COMPUTER port.
Adjusts the JUPITER-50's overall output
gain (except for the signal from the USB
COMPUTER port). If you're playing a fewer
-12–+12 [dB]
number of voices, boosting this setting can
help you obtain an optimal output level
when recording on an external device.
Sets the volume of the USB memory song
0–127
player.
Specifies whether the currently sounding
notes will remain (ON) or not (OFF) when you
select a different sound.
OFF, ON
* In some cases, the effect sound might not
remain.
Upper Part
Solo Part
Percussion/Lower Part
Reverb sound
The sound from the USB memory song player and the AUDIO
IN jack
The sound from USB audio
The metronome sound
75