System Settings; Factory Reset - Roland JX-08 Owner's Manual

InT The unit operates according to its
internal clock. Select this when using this unit by
itself.
NiDi The unit operates according to the
synchronization signal input from the MIDI
connector.
USB
The unit operates according to the
synchronization signal input from the USB
port.
Syn.O
[6] This sets the jack used to output the
synchronization signal.
OFF
A synchronization signal is not
output.
NiDi
A synchronization signal is output
from the MIDI connector.
USB A synchronization signal is output
from the USB port.
ALL A synchronization signal is output
both from the MIDI connector and the
USB port.
thrv
[7] OFF, On
If this is ON, MIDI messages that are input
from the MIDI IN connector are re-transmitted
as-is from the MIDI OUT connector.

SYSTEM SETTINGS

Configures the system settings.
[1] In.LU 0–127
Adjusts the input level of the MIX IN jack.
[2] A.Off OFF, 30, 240 (minutes)
Specifies whether the unit will turn off
automatically after a certain time has elapsed.
If you don't want the unit to turn off automatically,
choose "OFF" setting.
The setting is disabled (the power does not turn off
automatically) when the unit is connected via USB.
[3] tunE 415.3 – 466.2 (Hz)
Adjusts the overall tuning.
The value shown is the frequency of the A4 key (middle
A on a piano keyboard).
You can also press a step button to select the
parameter items.
USING THE UTILITIES
The utilities on this unit provide functionality that's
useful when editing.
P.CLr
[1] Initializes the selected pattern.
[2] T.CLr
Initializes the selected tone.
[3] T.rnd
Replaces the currently selected tone with a
random tone.
You can also press a step button to select the
parameter items.
RESTORING THE FACTORY SETTINGS
Returns the JX-08 to its factory defaults.
1. While holding down the PART [B] button, turn on the
power. The PAGE/TIE button blinks. To cancel the
factory reset, turn off the power.
2. Press the PAGE/TIE button.
Initialization begins. Once the JX-08 is restored to
factory default settings, "donE" appears in the display.
3. Turn the power of the JX-08 off and then on again.
35