Roland Jupiter-50 Owner's Manual page 97

SuperNATURAL
CC65
Acoustic Tone
0104 APS Oboe
Portamento
0105 APS English Horn Portamento
0106 APS Bassoon Portamento
0107 APS Clarinet Portamento
0108 APS Piccolo Portamento
0109 APS Flute
Portamento
0110 APS Pan Flute Portamento
0111 APS Shakuhachi Portamento
0112 APS Ryuteki Portamento
0113 APS Sitar Portamento
0114 APS UilleannPipe
Portamento
0115 APS Erhu Portamento
0116 APS Sarangi Portamento
0117 APS Steel Drums Portamento
*1 The setting of System Control 1 Source is used. With the factory settings, CC01 is assigned.
*2 The setting of System Control 2 Source is used. With the factory settings, AFTERTOUCH is assigned.
*3 Regardless of the System Control 1 Source setting, this can always be controlled by CC01.
*4 Mute: Simulates the technique of using a hand or mallet to stop the vibration (sound) of the instrument. Higher values will produce stronger muting.
*5 Mute: Simulates the technique of using a hand to stop the vibration of the string.
*6 Bend Mode: If Bend Range is set to anything other than Tone, operating the pitch bend lever when Bend Mode (CC19) is ON will produce a bellows tremolo effect.
Use this if you want to switch between the tremolo effect and conventional pitch change.
*7 Bend Mode: If Bend Range is set to anything other than Tone, operating the pitch bend lever when Bend Mode (CC19) is ON will simulate the wah effect produced
by cupping the hands around the instrument. Use this when you want to switch between the wah effect and conventional pitch change.
*8 Bend Mode: If Bend Range is set to anything other than Tone, operating the pitch bend lever when Bend Mode (CC19) is ON will produce a discontinuous pitch
change. Use this if you want to switch between discontinuous pitch change and conventional pitch change.
*9 Bend Mode: If Bend Range is set to anything other than Tone, operating the pitch bend lever when Bend Mode (CC19) is ON will produce a glissando effect. Use this
if you want to switch between glissando playing and conventional pitch change.
*10 The sound of the corresponding technique will be produced.
CC01 (System Control 1
CC76
Source) *1
– Dynamics+Vibrato
– Dynamics+Vibrato
– Dynamics+Vibrato
– Dynamics+Vibrato
– Dynamics+Vibrato
– Dynamics+Vibrato
– Dynamics+Vibrato
– Dynamics+Vibrato
– Dynamics+Vibrato
– Vibrato
– Dynamics
– Dynamics+Vibrato
– Dynamics
– Roll Sw+Dynamics (*3)
AFTERTOUCH
(System Control 2
Source) *2
Vibrato
Vibrato
Vibrato
Vibrato
Vibrato
Vibrato
Vibrato
Vibrato
Vibrato
Vibrato
Vibrato
Vibrato
Vibrato
–
Parameter List
97