Hawking HWABN25 User Manual page 68

Channel
Number (4):
Associated Clients (5): Click 'Show Active Clients' button, then an "Active Wireless
Root AP SSID (6):
Site Survey (7):
After you finish the wireless setting, please click 'Apply' button, after you click 'Apply',
the following message will be displayed on your web browser:
Please click 'Continue' to back to previous setup menu; to continue on router setup, or
click 'Apply' to reboot the router so the settings will take effect (Please wait for about 30
seconds while router is rebooting).
is used to identify your own wireless router from others when
there are other wireless routers in the same area. Default SSID
is 'Hawking_HWABN25', it's recommended to change default
ESSID value to the one which is meaningful to you, like myhome,
office_room1, etc.
Select the channel you want to use, all the wireless
clients must use the same setting as your original wireless signal
Client Table" will pop up. You can see the status of all active
wireless stations that are connecting to the access point.
In 'Universal Repeater' mode, this device can act as a station to
connect to a Root AP. You should assign the SSID of the Root AP
here or click 'Select Site Survey' button to choose a Root AP.
The Root AP is the name of the wireless signal you are trying to
repeat.
Click 'Select Site Survey' button, then a "Wireless Site Survey
Table" will pop up. It will list all available access points near by.
You can select one access point in the table and the router will
join wireless LAN through this access point.
67