Hawking HWABN25 User Manual page 46

Main SSID (3):
Channel Number (4):
Associated Clients (5): Click 'Show Active Clients' button and a new popup window will
Mac Address (6):
Set Security (7):
Adv. IP Address (8)
When you finish with all settings, please click 'Apply' (9); Connect you're your wireless
devices to the WDS network. Note: You must setup other devices in WDS mode in
order for this to work properly. Congratulations, you have set up the HWABN25 in AP
Bridge-WDS!
clients to connect to this access point, select 2.4GHz (B+G+N).
Please input the ESSID (the name used to identify this wireless
access point) here. You can input up to 32 alphanumerical
characters. PLEASE NOTE THAT ESSID IS CASE
SENSITIVE.
Please select a channel number you wish to use. Please note
that this should be the same channel as the other WDS devices
you plan to connect to.
appear which contains the information about all wireless clients
connected to this access point. You can click 'Refresh' button in
popup window to keep information up-to-date.
Please input the MAC addresses of the other WDS devices you
wish to make a connection with.
Click this button to select an encryption mode for this wireless
link, a new popup window will appear. Note: the security must
be the same on the other WDS Devices
This section allows you to set an IP Address and subnet mask to
fit your network if needed. Uncheck the box to input.
Otherwise, the default IP Address is 192.168.1.241.
45