Epson PowerLite Pro Z8000WUNL User Manual page 91

Problem Solving
Check
Is an extension cable being used?
Is the correct resolution selected?
Only when projecting computer images
Are the "Sync." and "Tracking" settings adjusted correctly?
Only when projecting computer images
The image is truncated (large) or small, or the aspect is not suitable
Check
Is the aspect adjusted correctly?
Is a wide panel computer image being projected?
Only when projecting computer images
Is the image still being enlarged by E-Zoom?
Is Position adjusted correctly?
Is the computer set for dual display?
Only when projecting computer images
Is the correct resolution selected?
Only when projecting computer images
If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with
the projector to check if the cables you are using may be causing the problem.
Set the computer so that the signals being output are compatible with the projector.
For more information, see your computer documentation.
Press the [Auto] button on the Remote Control or the [Enter] button on the Control panel to perform
automatic adjustment. If the images are not adjusted correctly after using automatic adjustment, you
can make the adjustments using Sync. and Tracking from the configuration menu. s Signal Menu -
Tracking, Sync. p.62
Press the [Aspect] button on the Remote Control to select an aspect suitable for the input source.
p.42
s
Change the setting according to the signal for the connected equipment. s Signal Menu - Resolution
p.62
Press the [Esc] button on the Remote Control to cancel E-Zoom. s
Press the [Auto] button on the Remote Control or the [Enter] button on the Control panel to perform
automatic adjustment when the computer image is projected. If the images are not adjusted correctly
after using automatic adjustment, you can make the adjustments using Position from the configuration
menu.
Apart from computer image signals, you can adjust other signals while projecting by adjusting Position
from the configuration menu. s Signal Menu - Position
If dual display is activated in the "Display Properties" of the computer's Control panel, only about half of
the image on the computer screen is projected. To display the entire image on the computer screen,
turn off the dual display setting. s Computer video driver documentation
Set the computer so that the signals being output are compatible with the projector.
s Computer documentation
Remedy
Remedy
p.47
p.62
91