Epson PowerLite Pro Z8000WUNL User Manual page 138

General Notes
• Never open any covers on the projector except as specifically explained
in this User's Guide. Never attempt to disassemble or modify the
projector. Refer all repairs to qualified service personnel.
• Use the type of power source indicated on the projector. Use of a
different power source may result in fire or electric shock. If you are not
sure of the power available, consult your dealer or power company.
• If you use the projector in the country where it was purchased, only use
the power cable that came with the projector. If you use the projector in
a country other than where you purchased it, use the correct power
cord for that country.
• Do not overload wall outlets, extension cords, or power strips. Do not
insert the plug into a dusty outlet. This can cause fire or electric shock.
• Take the following precautions when handling the plug: Do not hold
the plug with wet hands. Insert the plug firmly into the outlet. Do not
pull the power cord when disconnecting the plug; always be sure to
hold the plug when disconnecting it. Failure to comply with these
precautions could result in fire or electric shock.
• Do not place the projector where the cord can be walked on.
•
The lamp(s) in this product contain mercury. Please consult your
state and local regulations regarding disposal or recycling. Do not put
in the trash.
• Do not place anything that can become warped or damaged by heat
near the exhaust vents. Do not bring your hands or face close to the
vents while projection is in progress.
• Do not bring your face close to the projector while it is in use.
• Do not disassemble or damage the lamp or subject it to any impacts.
• Before you move the projector, make sure its power is turned off, the
plug is disconnected from the outlet, and all cables are disconnected.
• Do not project images while the detachable lens cover is still attached.
Heat may cause the lens cover to melt, and if you touch the lens cover
you could get burned.
• Do not touch the lens with bare hands.
• Always attach the lens cover to the lens when not using the projector, to
prevent the lens from becoming dirty or damaged.
• Never try to remove the lamp immediately after use because it will be
extremely hot. Before removing the lamp, turn off the power and wait
at least an hour to allow the lamp to cool completely.
• Do not place the source of an open flame, such as a lit candle, on or near
the projector.
• Do not modify the power cord. Do not place heavy objects on top of the
power cord or bend, twist, or pull it excessively. Keep the power cord
away from hot electrical appliances.
• If the lamp breaks, ventilate the room to prevent gases contained in the
lamp from being inhaled or coming in contact with the eyes or mouth.
• If the projector is mounted overhead and the lamp breaks, be careful to
prevent pieces of glass from falling into your eyes when you open the
lamp cover.
WARNING: The cords included with this product contain chemicals,
including lead, known to the State of California to cause birth defects or
other reproductive harm. Wash hands after handling. (This notice is
provided in accordance with Proposition 65 in Cal. Health & Safety Code
§ 25249.5 and following.)
138