Switch To The Target Image Using The Remote Control - Epson PowerLite Pro Z8000WUNL User Manual

Changing the Projected Image
Procedure
When your video equipment is connected, start playback before
beginning this operation.
Using the Remote Control
When two or more pieces of equipment are connected, press the [Source
Search] button until the target image is projected.
The following screen showing the status of image signals is displayed
when only the image that the projector is currently displaying is
available, or when no image signal can be found. You can select the input
port where the equipment you want to use is connected. If no operation
is performed after about 10 seconds, the screen closes.
Using the Control panel

Switch to the target image using the Remote Control

You can change directly to the target image by pressing the following
buttons on the Remote Control.
Remote Control
1 Changes to images from the Computer input port.
2 Changes to images from the Video input port.
3 Changes to images from the S-Video input port.
4 Does not function for this unit.
5 Each time the button is pressed, switches between images from
the DVI-D and HDMI input ports.
6 Changes to images from the BNC input port.
39