Epson PowerLite Pro Z8000WUNL User Manual page 85

Problem Solving
Status
If the projector is not operating properly, even though the indicators are all showing normal, refer to "When the Indicators Provide No Help". s
If the error is not indicated in this table, Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s
Cause
Low Air Flow (This is not an abnormality. However, projection stops automatically if the airflow falls any further.)
The message "The air filter is clogged. Clean or replace the air filter." is displayed. Check the following two
points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
If the Low Air Flow continues to be low after cleaning the air filter, replace the air filter with a new one.
If the error continues after checking the points above, stop using the projector, disconnect the power cable
from the electrical outlet, and contact Epson. s
Cln. Air Filter Notice The message "Time to clean the air filter. Clean or replace the air filter." is displayed. Clean the air filter.
If the air filter is stained yellow with tobacco smoke and cannot be cleaned, replace it with a new one.
The indicators or messages regarding "Cln. Air Filter Notice" are displayed only when Cln. Air Filter Notice is
set to On, on the configuration menu's Extended menu. s
Remedy or Status
p.96
p.66
85
p.86
p.96