Table of Contents
Advertisement
HS-600 Monitor
HDMI, PREVIEW, PROGRAM
Select the type of input you wish to view - HDMI, PREVIEW or PROGRAM. The active selection will be indicated by
a red LED on the chosen button.
When you select ''PROGRAM'', you select the mixed program output of the HS-600; this is a full screen display.
When you select ''PREVIEW'', you will see a multi-image preview from the mixer.
When you select ''HDMI'', you select the HDMI source input on Rear Panel; this is a full screen display like
Program and could be the input from a recorder for confidence monitoring of the recording.
BLUE
Press this button to eliminate the red and green component of input signals. Only the blue component of an input is
displayed on the screen. This allows adjustments of chroma and phase. (Phase adjustment is effective with NTSC
signals).
PATTERN
Press this button to display the monitors built in SMPTE colour bars pattern. This feature can be used to calibrate
or change the monitor settings when using the OSD menu options.
PIP
The monitor's own PIP or Picture in Picture feature allows you to display two sources at the same time. One source
will display as a full screen with the secondary source on a smaller PIP window. The mixed program output is
CVBS2. The rear HDMI input (not mixed) is HDMI1. The multi-image preview is HDMI 2.
NOTE: The OSD Menu PIP options for SDI, COMP, SVIDEO and CVBS1 cannot be used as they are not
connected to the HS-600 monitor.
Menu Navigation Buttons
The MENU, arrow up, arrow down and ENTER buttons are used to display and navigate the OSD set up menus.
When not using the OSD menus the arrow down button also toggles the Safe Area Mask On or Off. This feature
may need to be set up using the OSD menus first.
When not using the OSD menus the arrow up button also toggles the 4:3 Mask On or Off when in 16:9 mode.
This feature may need to be set up using the OSD menus first.
MUTE Button
Mutes the audio from the internal speakers or headphone socket.
Volume Control
Adjusts the speaker / headphone volume up / down.
Aspect Ratio Button
Toggles the Aspect Ratio of the display between 16:9 and 4:3
The 17.3" display built into the HS-600 lid has controls which allow
selection of source inputs for Mixer Program, Mixer Preview or
HDMI input as well as PIP, Aspect Ratio, Blue only, Pattern
(Colour Bars), Menu and Audio.
The monitor's On Screen Display (OSD) MENU, arrow buttons
and ENTER button allow control and set up of brightness, contrast,
saturation, hue, sharpness and colour temperature. Additional
menus can also be used to display Picture in Picture, onscreen
overlays for 80% or 90% Frame Marker, 4:3 Marker, 16:9 Marker,
Cinema Zone Marker, and Centre Point.
44
Advertisement
Table of Contents
