Table of Contents
Advertisement
Multi-Image Preview
The HS-600 Multi-Image Preview is supplied from the DVI-D connection on the rear panel and also to the 17.3"
monitor built into the case lid. When connected to a compatible DVI-D monitor the above multi-image layout is seen.
Alternatively you could use a DVI-D to HDMI cable and take this into a HDMI monitor instead. Please note not all
monitors are compatible, please double check with your chosen monitor beforehand. For optimal picture and
colour performance use a Datavideo TLM-170H, HR or HM type monitor.
The first two rows of images on this Preview show the live sources 1~8 coming into the mixer and also the
assigned auxiliary outputs AUX1, AUX2. Below these two rows of images are two larger images. One for the
Preview (PST_SUB) and one for the Program (PGM_MAIN) outputs.
In between the PST and PGM images is the HS-600 Status Display and below it the Settings Display. When the
Settings Menus are not in use you will see audio peak meters here instead as shown above.
The HS-600 Multi-Image Preview also supplies basic tally information by highlighting the live Program source with
a red border, and the cued next source with a yellow border. If BG (background colour), PIP (Picture in Picture) or
Luma Key are enabled then these red or yellow tally indicators may not be present. In these situations the Status
Display in the centre of the Multi Image Preview will confirm what image is being sent to Preview (PST) and
Program (PGM). In the above example input 4 is being sent to PGM and PST is being fed with a PIP image, so
only image 4 is highlighted with a red border.
For more information on changing the Multi-Image Preview see page 36.
12
Advertisement
Table of Contents
