Itc-50 Intercom; Itc-50 Connections And Controls - Datavideo HS-600 Instruction Manual

ITC-50 Intercom

The built in ITC-50 intercom system provides communication and tally indications from the director to the crew. The
director working at the HS-600 keyboard can choose to talk to a single belt pack channel or to all channels.
CB-3 5pin XLR cabling connects between the rear panel of the HS-600 and the supplied belt packs. These belt
packs also provide cued (amber) and live (red) tally signals from the HS-600 video switcher to an attached TD-1
tally light.
The HS-600 comes with single ear and mic MC-1 starter headsets. These headsets can be used with the belt
packs or at the director's position on the HS-600. Alternatively the director can work with standard headphones
using the ¼" headphone socket and the supplied XLR gooseneck condenser microphone.

ITC-50 connections and Controls

USB Power socket
This socket is for use with the supplied USB LED keyboard light. This socket is not a
data connection and should not be connected to a computer.
SAFETY FIRST Remember to unplug the USB light before attempting to close the lid
of the HS-600 otherwise you may damage the USB Socket, Light and Monitor.
XLR Microphone Socket
Combined XLR / ¼" ( 6.3mm ) Jack Microphone Input for either a Condenser or
Dynamic Gooseneck Microphone. If a headset with mic is used at the 3.5mm socket
then the XLR microphone is made redundant.
XLR 3pin connector supports Condenser Microphones.
Centre ¼" ( 6.3mm ) Jack socket supports Dynamic Microphones.
ALL Button
Opens communication with all channels. All channels will hear communication from
the operator, or from any other channel using the TALK button.
Channel Buttons 1~8
Opens communication with individual channels. More than 1 channel can be active at
any given time, active channels are illuminated red.
All active channels will hear any communication from the operator or from any other
active channel.
The buttons will also indicate if any channel is paging, the paging channel will flash in
orange until the page is answered.
MUTE Button
Mutes all communication from the base station or any channel.
NOTE If any channel uses the CALL button the paging tone will still sound even when
the MUTE button is active.
Headphone/Headset Volume Control
A headset and/or headphones can be used to monitor ITC-50
communication at the HS-600 keyboard. See pages 33 and 9.
41