Video Input Adjustment - Datavideo HS-600 Instruction Manual

Video Input Adjustment

It is possible to adjust the Composite or DVI video signals within the Datavideo HS-600 switcher. However, it is
always better to try to produce the best video signal possible from the input equipment first.
For example, if the connected video equipment is a live camera then it should be possible to white balance the
camera and reset its exposure level after any stage lighting has been set up. The cameras manual should explain
how to do this properly. This should ensure that the camera is feeding good pictures to the mixer. It should be very
rare that video input should still need adjusting within the HS-600, especially if the camera and lighting have
already been set up correctly.
For the same reasons any pre-recorded, or B Roll, video should be reviewed before being used in the production.
1: COUNT_DOWN_TIME
2: PIP
3: CG (LUMA KEY)
4: LOGO
5: VIDEO IN & OUT
6: AUDIO MIXER
7: MULTI. IMAGE
8: SYSTEM
9: STORE RECALL & UPDATE
10: RESET DVI_IN
ESCAPE
[ IN / OUT SELECT ]
1: INPUT
2: OUTPUT
3. FRAME STORE
4: ASSIGN VIDEO SOURCES
5: DV & SDI_OUT
ESCAPE
VIDEO CH. : IN_1
1: INPUT TYPE = CV
2: BRIGHTNESS = +00
3: CONTRAST = +00
4: SATURATION = +00
5: RGB CORRECTION : X_+00 Y_+00
6: AGC = ON
7: 7.5IRE = NC
ESCAPE
VIDEO CH. : IN_8
1: INPUT TYPE = DVI_D
2: BRIGHTNESS = +00
3: CONTRAST = +00
4: SATURATION = +00
5: RGB CORRECTION : X_+00 Y_+00
6: _ _ _
7: _ _ _
8: DVI INPUT MODE = 1024x768 , 60Hz
9: DVI DISP. SIZE
ESCAPE
The HS-600 is set up by a series of menus. Once the initial settings
have been chosen they are stored within the system, so it may only be
necessary to make these changes once.
When the SETTING button is pressed in the EFFECTS area of the
HS-600 keyboard the Main Menu list, shown left, is displayed between
the PST and PGM images on the Multi-Image Preview output.
This menu option allows the user to change settings which effect video
coming into or going out of the HS-600. Use the arrow buttons to
highlight the VIDEO IN & OUT item then press the ENTER button to
confirm the selection.
= 100%
For Composite CV inputs 1 to 6 the options will be as follows.
This value will change according to your input choice above.
Brightness can be adjusted up or down
Contrast can be adjusted up or down
Saturation can be adjusted up or down
RGB Correction X and Y can be adjusted [ range -37 to +36 ]
Automatic Gain Control is only used with Composite CV inputs
Used on NTSC models only – Sets IRE (black level) to 0 or 7.5.
For DVI inputs 7 and 8 the options will be as follows.
This value can be changed on input 8 only to DVI_A or DVI_D.
Brightness can be adjusted up or down
Contrast can be adjusted up or down
Saturation can be adjusted up or down
RGB Correction X and Y can be adjusted [ range -37 to +36 ]
These settings cannot be changed.
28
[ range -99 to +99 ]
[ range -99 to +99 ]
[ range -99 to +99 ]
[ range -99 to +99 ]
[ range -99 to +99 ]
[ range -99 to +99 ]