Table of Contents
Advertisement
ITEM
Manual Timeout
Wait Timeout
Low Toner
Jam Recovery
Error Report
PCL emulation
ITEM
CHOICE
Font Source
RESIDENT /
RESIDENT 2
Font No.
I0~I89
Font Pitch
0.44 CPI~10.00
CPI~99.99 CPI
Symbol Set
PC-8
CHOICE
OFF
30 sec
60 sec
5~40~300
OFF
CONTINUE
STOP
ON/OFF
ON/OFF
Configuring your machine > 49
DESCRIPTION
Specifies how many seconds the MFP
will wait for paper to be fed before
cancelling the job.
Specifies how many seconds the MFP
will wait when received data pauses
before forcing a page eject. In
PostScript Emulation mode the job will
be cancelled if timeout occurs.
Specifies whether the MFP should
continue printing even after a low toner
condition is detected.
Specifies whether the MFP should
perform jam recovery after a paper jam
has occurred. If ON, the MFP will
attempt to print again any pages lost
due to a paper jam once the jam has
been cleared.
If ON, the MFP will print error details
when a PostScript Emulation error
occurs.
DESCRIPTION
Specifies the location of the PCL
default font. Normally this will be
INTERNAL unless additional fonts are
installed in the expansion ROM slot or
additional fonts have been
downloaded to RAM as permanent
fonts.
Sets the current default font number
from the currently selected source,
which could be internal (I), ROM slot
(C) or downloaded (S).
Point size of selected default font.
PCL symbol set. If the font source and
number are changed to one which
does not support the selected symbol
set, this must be changed to an
available symbol set for that font.
Advertisement
Table of Contents
