Table of Contents
Advertisement
5. Locate the two fasteners (5) at each side of the belt and the
lifting bar (6) at the front end.
6. Turn the two fasteners 90° to the left. This will release the
belt from the MFP chassis.
7. Pull the lifting bar (6) upwards so that belt tilts up towards
the front, and withdraw the belt unit from the MFP.
8. Lower the new belt unit into place, with the lifting bar at the
front and the drive gear towards the rear of the MFP. Locate
the drive gear into the gear inside the printer by the rear left
corner of the unit, and lower the belt unit flat inside the MFP.
9. Turn the two fasteners (5) 90° to the right until they lock.
This will secure the belt unit in place.
10. Replace the four image drums, complete with their toner
cartridges, into the printer in the same sequence as they
came out: cyan (nearest the rear), magenta, yellow and
black (nearest the front).
11. Close the top cover and press down firmly at both sides so
that the cover latches closed.
5
6
5
Maintenance > 122
Advertisement
Table of Contents
