Table of Contents
Advertisement
I
MAGE OF RECEIVED FAX IS VERY POOR
Try making a copy of a document on the local machine to make
sure it is working properly. If there is still a problem, contact the
person sending the fax and ask them to change their fax quality
and density settings. Ask the person to make a copy of the
document on their machine to ensure that it is working properly.
Then ask them to send the fax again.
D
IALING WAS TRIED WITH A
HAPPENED
Make sure that the Speed Dial number being used is programmed
correctly.
L
MFP
OCAL
WILL NOT ANSWER THE TELEPHONE OR RECEIVE FAXES
First check to see that the power cord is connected properly. Also
check the reception mode setting of the machine. This MFP will
not receive faxes automatically if the manual receive mode is
enabled
(See "Manual receive" on page
D
OCUMENTS RECEIVED ARE LIGHT OR HAVE VERTICAL STREAKS ON
,
MFP
THEM
AND
Gently wipe the lens surface of the MFP's LED array, and then
check to see if the machine is working properly
LED head" on page
remove the image drum
page
114.), tap the toner cartridge, and slowly swing it 20 to 30
degrees vertically several times. Be careful not to let the toner
leak from the cartridge. If this does not work, the image drum
unit may need to be replaced. Contact your supplier to get a
replacement.
MFP
IS SET FOR DELAYED TRANSMISSION BUT IT DID NOT SEND
Check the display to make sure that the MFP is set to the correct
time and date
(See "Initial set up" on page
S
PEED
IS NOT OUT OF TONER
128.). If the MFP still does not work properly,
(See "Image drum replacement" on
Troubleshooting > 153
D
IAL NUMBER BUT NOTHING
63.).
(See "Clean the
57.).
Advertisement
Table of Contents
