Table of Contents
Advertisement
Enable
Prefix Number
Mode
OP Number
Min Len
Max Len
Interface
3
.
6
.
2
S
I
P
A
c
c
3
.
6
.
2
S
I
P
A
c
c
In this section, you set up your own SIP settings. When you apply for an account, your SIP
service provider will give you an Account Name or user name, SIP Registrar, Proxy, and
Domain name. (The last three might be the same in some case). Then you can tell your folks
your SIP Address as in Account Name@ Domain name
As Vigor VoIP Router is turned on, it will first register with Registrar using
AuthorizationUser@Domain/Realm. After that, your call will be bypassed by SIP Proxy to the
destination using AccountName@Domain/Realm as identity.
Note: Vigor VoIP router supports three SIP accounts from firmware version 2.5.9
and later.
Vigor2100 Series User's Guide
Check this box to invoke this setting.
The phone number set here is used to add, strip, or replace the OP
number.
None - No action.
Add - When you choose this mode, the OP number will be added
with the prefix number for calling out through the specific VoIP
interface.
Strip - When you choose this mode, the OP number will be deleted
by the prefix number for calling out through the specific VoIP
interface. Take the above picture (Prefix Table Setup web page) as
an example, the OP number of 886 will be deleted completely for the
prefix number is set with 886.
Replace - When you choose this mode, the OP number will be
replaced by the prefix number for calling out through the specific
VoIP interface. Take the above picture (Prefix Table Setup web page)
as an example, the prefix number of 03 will be replaced by 8863. For
example: dial number of "031111111" will be changed to
"88631111111" and sent to SIP server.
The front number you type here is the first part of the account
number that you want to execute special function (according to the
chosen mode) by using the prefix number.
Set the minimal length of the dial number for applying the prefix
number settings. Take the above picture (Prefix Table Setup web
page) as an example, if the dial number is between 7 and 9, that
number can apply the prefix number settings here.
Set the maximum length of the dial number for applying the prefix
number settings.
Choose the one that you want to enable the prefix number settings
from the four pre-saved SIP accounts (including PSTN).
o
u
n
t
s
o
u
n
t
s
59
Advertisement
Table of Contents
