Table of Contents
Advertisement
Time Zone
Enable Daylight Saving
Automatically Update
Interval
Click OK to save these settings.
3
.
8
.
6
M
a
n
a
g
e
3
.
8
.
6
M
a
n
a
g
e
This page allows you to manage the settings for access control, access list, and port setup. For
example, as to management access control, the port number is used to send/receive SIP
message for building a session. The default value is 5060 and this must match with the peer
Registrar when making VoIP calls.
Enable remote
firmware upgrade
Allow management
from the Internet
Disable PING from
the Internet
Access List
Default Ports
User Defined Ports
3
.
8
.
7
R
e
b
o
o
t
3
.
8
.
7
R
e
b
o
o
t
The Web Configurator may be used to restart your router. Click Reboot System from System
Maintenance to open the following page.
84
Select the time zone where the router is located.
Check this box to invoke daylight saving function.
Select a time interval for updating from the NTP server.
m
e
n
t
S
e
t
u
p
m
e
n
t
S
e
t
u
p
Chick the checkbox to allow remote firmware upgrade through FTP
(File Transfer Protocol).
Enable the checkbox to allow system administrators to login from
the Internet. By default, it is not allowed.
Check the checkbox to reject all PING packets from the Internet. For
security issue, this function is enabled by default.
You could specify that the system administrator can only login
from a specific host or network defined in the list. A maximum of
three IPs/subnet masks is allowed.
List IP - Indicate an IP address allowed to login to the router.
Subnet Mask - Represent a subnet mask allowed to login to the
router.
Check to use standard port numbers for the Telnet and HTTP
servers.
Check to specify user-defined port numbers for the Telnet and HTTP
servers.
S
y
s
t
e
m
S
y
s
t
e
m
Vigor2100 Series User's Guide
Advertisement
Table of Contents
