Table of Contents
Advertisement
that this action will not introduce any delay in your Web surfing because each of multiple load
balanced database servers can handle millions of requests for categorization.
Below shows the menu items of Firewall.
3
.
4
.
2
G
e
n
e
r
a
3
.
4
.
2
G
e
n
e
r
a
General Setup allows you to adjust settings of IP Filter and common options. Here you can
enable or disable the Call Filter or Data Filter. Under some circumstance, your filter set can
be linked to work in a serial manner. So here you assign the Start Filter Set only. Also you
can configure the Log Flag settings, Enable Stateful packet inspection, Drop non-http
connection on TCP port 80, and Accept incoming fragmented UDP packets.
Click Firewall and click General Setup to open the general setup page.
Call Filter
Data Filter
Log Flag
MAC Address for
Logged Packet
Duplication
Vigor2100 Series User's Guide
l
S
e
t
u
p
l
S
e
t
u
p
Check Enable to activate the Call Filter function. Assign a start filter
set for the Call Filter.
Check Enable to activate the Data Filter function. Assign a start filter
set for the Data Filter.
For troubleshooting needs you can specify the filter log here.
None - The log function is not activated.
Block - All blocked packets will be logged.
Pass - All passed packets will be logged.
No Match - The log function will record all packets that are not
matched.
Note that the filter log will be displayed on the Telnet terminal when
you type the log -f command.
Logged packets may also be logged to another location via
Ethernet. If you want to duplicate logged packets from the router
to another network device, you must enter the other devices' MAC
Address (HEX Format). Type "0" to disable the feature. The
feature will be helpful under Ethernet environments.
37
Advertisement
Table of Contents
