Sip Accounts - Draytek Vigor 2910 User Manual

OP Number
Min Len
Max Len
Interface
3 . 1 0 . 2 S I P A c
3 . 1 0 . 2 S I P A c
In this section, you set up your own SIP settings. When you apply for an account, your SIP
service provider will give you an Account Name or user name, SIP Registrar, Proxy, and
Domain name. (The last three might be the same in some case). Then you can tell your folks
your SIP Address as in Account Name@ Domain name
As Vigor VoIP Router is turned on, it will first register with Registrar using
AuthorizationUser@Domain/Realm. After that, your call will be bypassed by SIP Proxy to
the destination using AccountName@Domain/Realm as identity.
Index
128
c o u n t s
c o u n t s
SIP server.
The front number you type here is the first part of the account
number that you want to execute special function (according
to the chosen mode) by using the prefix number.
Set the minimal length of the dial number for applying the
prefix number settings. Take the above picture (Prefix Table
Setup web page) as an example, if the dial number is between
7 and 9, that number can apply the prefix number settings
here.
Set the maximum length of the dail number for applying the
prefix number settings.
Choose the one that you want to enable the prefix number
settings from the saved SIP accounts. Please set up one SIP
account first to make this interface available.
Click this link to access into next page for setting SIP account.
Vigor2910 Series User's Guide