Error Handling - Intermec EasyCoder PD4 Service Manual

Chapter 14—Troubleshooting

14.1 Error Handling

90
When an error occurs, the Error LED goes solid or fl ashing red and the
beeper emits two beeps. Provided the printer is fi tted with a display, two
error message are displayed alternatingly, for example:
When all errors have been cleared, the Error LED goes off, the beeper
emits a single beep, and the printer returns to the same mode as when the
error occurred, which is indicated in the display window.
The printer's error-handler can manage the following errors:
Description/Display Message
01: Syntax error
02: Object exceeds image buffer border
03: Data length error
04: Insuffi cient memory to store data
05: Memory confi guration error
07: Out of media
08: Form or image name duplicate
09: Form or image not found
11: Print head lifted
13: Label taken sensor waiting
15: Rewinder is full
16: No form was retrieved before '?'
17: Out of ribbon
50: Does not fi t in area specifi ed
51: Data length too long
62: High print head temperature (WAIT)
71: Default Setup retrieved (RESET)
72: Flashing not completed (RESET)
73: Download error (RESET)
81: Cutter jammed or not installed
Action
Press the Feed key
Press the Feed key
Press the Feed key
Press the Feed key
Press the Feed key
Load new supply of media
Press the Feed key
Press the Feed key
Close the printhead
Remove label
Remove wound-up liner
Press the Feed key
Load new supply of ribbon
Press the Feed key
Press the Feed key
Wait for printhead to cool off
Switch power off/on or send ^@ cmd
Switch power off/on or send ^@ cmd
Switch power off/on or send ^@ cmd
Clear media from cutter or disable cutter
Intermec EasyCoder PD4—Service Manual