Error During Printing - Intermec EasyCoder PD4 Service Manual

14.4 Error During Printing

Intermec EasyCoder PD4—Service Manual
Description:
During printing, an error occurs:
• The printing stops
• The Error LED turns solid red.
• An error message appears in the display window (if any).
Possible Causes and Suggested Remedies:
• The printer is out of media or transfer ribbon (Error 07 or 17).
- Check and load a new supply if necessary.
• The printhead was not properly locked in closed position and has
lifted partly or completely (Error 11).
- Engage the printhead and make sure the printhead lever is locked.
- If the printhead actually is closed and locked, but error 11 is still
reported, the headlift sensor may be out of order. Check connection
to CN14 on the main board. Check headlift microswitch (see Chap-
ter 7.6) and replace if necessary.
• Check for jammed or entangled media or ribbon.
- If found, clear and reload. Clean parts that may have been exposed to
the media's adhesive using isopropyl alcohol or a cleaning card.
• Check if the light path between the upper and lower parts of the label
gap sensor is obstructed by dust, adhesive, or stuck labels.
- If so, clean using isopropyl alcohol or a cleaning card.
• Check for bad settings or program command errors.
- See the User's Guide or the ESim v5.xx for EasyCoder PD4, Program-
mer's Reference Manual.
Chapter 14—Troubleshooting
95