Configuring Optional Parameters Common To An Nqa Test Group - 3Com Switch 4800G 24-Port Configuration Manual

1062 C 86: NQA C
HAPTER
Configuring Optional
Parameters Common
to an NQA Test Group
ONFIGURATION
Configuring trap delivery
Follow these steps to configure trap delivery:
To do...
Enter system view
Enter NQA test group view
Enter test type view of the test
group
Configure to send traps to
network management server
under specified conditions
Optional parameters common to an NQA test group are valid only for tests in this
test group.
Unless otherwise specified, the following parameters are applicable to all test
types and they can be configured according to the actual conditions.
Follow these steps to configure optional parameters common to an NQA test
group:
To do...
Enter system view
Enter NQA test group view nqa entry admin-name
Enter test type view of a
test group
Configure the descriptive
string for a test group
Configure the interval
between two consecutive
tests for a test group
Configure the number of
probes in a test
Use the command...
system-view
nqa entry admin-name
operation-tag
type { dhcp | dlsw | ftp |
http | icmp-echo | snmp |
tcp | udp-echo | udp-jitter }
reaction trap
{ probe-failure
consecutive-probe-failures |
test-complete | test-failure
cumulate-probe-failures }
Use the command...
system-view
operation-tag
type { dhcp | dlsw | ftp |
http | icmp-echo | snmp |
tcp | udp-echo |
udp-jitter }
description string
frequency interval
probe count times
Remarks
-
-
-
Optional
No traps are sent to the
network management server
by default.
Remarks
-
-
-
Optional
By default, no descriptive string is
available for a test group.
Optional
By default, the interval between two
consecutive tests for a test group is
0 milliseconds, that is, only one test
is performed.
If the last test is not completed
when the interval specified by the
frequency command is reached, a
new test is not started.
Optional
By default, one probe is performed
in a test.