3Com Switch 4800G 24-Port Configuration Manual page 1190

1190 C 92: LLDP C
HAPTER ONFIGURATION
[SwitchA] interface GigabitEthernet1/0/1
[SwitchA-GigabitEthernet1/0/1] lldp enable
[SwitchA-GigabitEthernet1/0/1] lldp admin-status rx
[SwitchA-GigabitEthernet1/0/1] quit
[SwitchA] interface GigabitEthernet1/0/2
[SwitchA-GigabitEthernet1/0/2] lldp enable
[SwitchA-GigabitEthernet1/0/2] lldp admin-status rx
[SwitchA-GigabitEthernet1/0/2] quit
2 Configure Switch B.
# Enter system view.
<SwitchB> system-view
# Enable LLDP globally.
[SwitchB] lldp enable
# Enable LLDP on GigabitEthernet1/0/1, setting the LLDP operating mode to Tx.
[SwitchB] interface GigabitEthernet1/0/1
[SwitchB-GigabitEthernet1/0/1] lldp enable
[SwitchB-GigabitEthernet1/0/1] lldp admin-status tx
3 Verify the configuration.
# Display the global LLDP status and port LLDP status on Switch A.
<SwitchA> display lldp status
Global status of LLDP : Enable
The current number of neighbors : 2
Neighbor information last changed time : 0 days, 0 hours, 4 minutes, 40 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 0 [GigabitEthernet1/0/1] :
Port status of LLDP
Admin status
Trap flag
Roll time
Number of neighbors
Number of MED neighbors
Number of sent optional TLV
Number of received unknown TLV
Port 1 [GigabitEthernet1/0/2] :
Port status of LLDP
Admin status
Trap flag
Roll time
Number of neighbors
Number of MED neighbors
Number of sent optional TLV
Number of received unknown TLV
# Tear down the link between Switch A and Switch B and then display the global
LLDP status and port LLDP status on Switch A.
: 30s
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Rx_Only
: No
: 0s
: 1
: 1
: 0
: 0
: Enable
: Rx_Only
: No
: 0s
: 1
: 0
: 0
: 3