Chapter 4: Installing A New G700 Without An S8300 Using The Gateway Installation Wizard - Avaya G700 Installing Manual

Chapter 4: Installing a new G700 without an S8300
This chapter covers the procedures to install a new Avaya G700 Media Gateway without an
Avaya S8300 Media Server. The G700 is controlled by an external primary server running
Avaya Communication Manager. The primary server can be an S8400, S8500, or S8700-series
Media Server or an S8300 residing in another G700.
Note:
Procedures to install or upgrade an S8400, S8500, or S8700-series Media Server
Note:
are not covered in this document. See Documentation for Avaya Communication
Manager, Media Gateways and Servers, which is on the Avaya Support website
(http://www.avaya.com/support) or on the CD, 03-300151.
The Avaya Gateway Installation Wizard (GIW) performs these tasks automatically
Assigning the IP addresses of the G700 media gateway components
●
- Assigning the IP address for the P330 Stack Processor
- Establishing IP routing for the stack
- Assigning the IP address to the G700 media gateway processor
- Assigning the default IP route to the G700 media gateway
- Assigning IP addresses to the VoIP resources
- Checking for IP connections
Setting up the media gateway controller list
●
Setting the Link Loss Transition Points
●
However, the GIW does not configure an X330 Expansion module. This task you must still
perform manually, as described in:
Configure an X330 Expansion Module (If Necessary)
●
using the Gateway Installation Wizard
Issue 9.1 June 2006 199