Manual upgrade of an existing S8300A and G700 to R3.1
Upgrading the S8300B Media Server
Setting telnet parameters
●
Remastering the hard drive and installing the upgrade software
●
Verifying software version
●
Copying files to the S8300
●
Configuring network parameters
●
Verifying connectivity
●
Disabling RAM disk on the media server
●
Procedure One: Restoring data backup (if upgrading from a Pre-1.2 release)
●
Procedure Two: Restoring data backup (If upgrading from R1.2.x through 2.x)
●
Enabling RAM disk on the media server
●
Verifying the time, date, and time zone
●
Verifying media server configuration
●
Installing the new license file
●
Installing the new authentication file, if any
●
Saving translations (if not using IA770 and S8300 is not an LSP)
●
Verifying operation
●
Setting telnet parameters
The Microsoft Telnet application may be set to send a carriage return (CR) and line feed (LF)
each time you press Enter. The installation program sees this as two key presses. You need to
correct this before you Telnet to the server.
Note:
This procedure is done entirely on your laptop, not on the S8300.
Note:
To set telnet parameters
1. Click Start > Run to open the Run dialog box.
2. Type telnet and press Enter to open a Microsoft Telnet session.
3. Type unset crlf and press Enter.
4. Type display and press Enter to confirm that Sending only CR is set.
5. Type quit and press Enter to save the setting and close the window.
This procedure resets your Microsoft Telnet defaults and does not need to be done each time
you use Telnet.
622 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 622
on page 628
on page 629
on page 631
on page 632
on page 639
on page 639
on page 640
on page 642
on page 644
on page 634
on page 643
on page 623
on page 635
on page 636
on page 644