Avaya G700 Installing Manual page 751

Table 49: Equipment List: Media Modules (continued)
Media Modules
MM711 Analog Media
Module
The MM711 Analog Media Module supports eight analog interfaces allowing the
connectivity of Loop Start, Ground Start, Analog DID trunks, and 2-wire analog
Outgoing CAMA E911 trunks. As well, the MM711 Analog Media Module allows
connectivity of analog, tip/ring devices such as single line telephones, modems
or group 3 fax machines. Each port may be configured as either a trunk interface
or a station interface.
Also included is support for caller ID signaling, ring voltage generation for a
variety of international frequencies and cadences and administrable line
termination styles.
MM714 Analog Media
Module
The MM714 Analog Media Module supports four analog stations and four CO
trunks. Analog DID trunk connections are to be associated with the ports labeled
"Line" and not "Trunk".
MM712 DCP Media
Module
The MM712 DCP Media Module allows connectivity of up to 8 two-wire DCP
voice terminals. MM712 will not support 4-Wire DCP telephones.
Signal timing specifications for the MM712 support TDM Bus Timing in receive
and transmit modes. The G700 Media Gateway supplies only +5 VDC and –48
VDC to the MM712 Media Module. Any other required voltages must be derived
on the module.
Loop range secondary protection is provided on the MM712. The MM712 is also
self-protecting from an over current condition on a tip and ring interface.
MM716 24 port Analog
Media Module
The MM716 provides 24 analog ports supporting telephones, modem, and fax.
These ports can also be configured as DID trunks with either wink-start or
immediate-start. The 24 ports are provided via a 25 pair RJ21X amphenol
connector, which can be connected by an amphenol cable to a breakout box or
punch down block.
Comcode (for Services Ordering Only): 700277379
Comcode (for Services Ordering Only): 700277379
Comcode (for Services Ordering Only): 700315583
Comcode (for Services Ordering Only):
700302409
2 of 4
Issue 9.1 June 2006 751