1151B1/C1 And 1151B2/C2 Power Supplies - Avaya G700 Installing Manual

Telephones and adjunct systems
Power requirements are consistent with the 1152A1 PDU voltage and power ratings.
●
Refer to Appendix B in the user's guide that comes with the unit for voltage and power
ratings.
To connect telephones and other end devices to the 1152A1 PDU
1. Connect an Ethernet cable to the telephone using an external splitter or directly (if the
device is Power over LAN Enabled).
2. Connect the opposite end of the same cable to the RJ45 wall outlet.
3. On the front panel of the 1152A1 PDU, monitor the response of the corresponding port LED.
If it lights up GREEN, the unit has identified your telephone as a Power over LAN telephone.

1151B1/C1 and 1151B2/C2 power supplies

The 1151B1/C1 and 1151B2/C2 power supplies are local power supplies. The telephones or
consoles connect directly to them through an RJ45 connector. The 1151B2/C2 has a battery
backup.
These power supplies comply with the Underwriters Laboratories Inc. (UL) Standard UL 60950
third edition.
For safety instructions, see
supplies on page 371. For installation instructions, see
C2 power supplies
370 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Table 23: 1151B1/C1 and 1151B2/C2
Power Supply UL 60950 Compliance
Complies
Certified
Approved
Approved
Important safety instructions for 1151B1/C1 and 1151B2/C2 power
on page 372.
UL 60950
CSA 22.2
EN6950
CE
Connecting the 1151B1/C1 or 1151B2/