Pro-Form CrossXover User Manual page 8

7, Attach the Backrest (22) to the Upright (3) and
the Upright Base (1) with four M6 x 16mm
Screws (130),
Connect the Sensor Wire Harness (187), the Wire
Harness (159), and the Upper Wire Harness
(188) to the ConsoUe (71), Push the excess wire
into the Upright (3}.
The connector shoutd slide easily into the sock-
et and snap into place. Ufa connector does not
slide easily and snap into pUace,turn it over and
then insert it, IF THE CONNECTOR IS NOT
INSERTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER mS
TURNED ON.
Attach the ConsoUe (71) to the Upright (3) with
four M4 x 16mm Screws (85), Make sure that
the wires do not get pinched.
Attach the two SwiveUArms (58) to the Top Arm
(11) with two M4 x 5mm Screws (131),
10, Attach the Top Arm (11) to the Upright (3) with
two MIO x 75mm Patch Screws (99),
Route the Short CaMes (163) through the bracket
on the back of the Upright (3),
10
22
71
85
85
_85
58
131
11
58
11
99
3\
\
Bracket
8